Provisioning and Operating the SSU-2000
Overview of the SSU-2000 Security System
100 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
Changing Factory Defaults
Use the following steps to change the factory default or any configuration settings in
the SSU-2000. This example changes an alarm from minor to major.
1. Connect a computer to the SSU-2000 using the procedure in Establishing a
Connection With the SSU-2000, on page 88. The
SSU-2000> prompt appears.
2. Log in to the SSU-2000:
ICS command:
Type
login followed by the administrator’s user name and press Enter. The
system prompts for a password. Type the administrator’s password and press
Enter. The system prompt
SSU-2000> appears.
TL1 command:
Type
ACT-USER::uid:123::pwd; where uid and pwd are the administrator’s
user id and password, respectively; 123 is an arbitrary ctag value.
3. Type
alarm 1A12 03 (1=shelf; 12=slot; 03=alarm number), and press Enter.
4. Type
alarm 1A12 and press Enter to verify that 03 changed to major.
5. Type
bye and press Enter to log off the system.
Customizing Other Configuration Options
The SSU-2000 allows you to change any or all configuration settings. Use the
following procedures to customize the system for a particular environment.
1. Connect a computer to the SSU-2000 using the procedure in Establishing a
Connection With the SSU-2000, on page 88. The
SSU-2000> prompt appears.
2. Log in to the SSU-2000:
ICS command:
Type
login followed by the administrator’s user name and press Enter. The
system prompts for a password. Type the administrator’s password and press
Enter. The system prompt
SSU-2000> appears.
TL1 command:
Type
ACT-USER::uid:123::pwd; where uid and pwd are the administrator’s
user id and password, respectively; 123 is an arbitrary ctag value.
To Next Page
Loading...
Need help?
General
