12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 261
Event Messages
LBO, Port[2-3], 266 ft, COML 194
Line build out on ports 2 and 3 set to 266 ft.
SlipCount, Port[2-3], 4, COML 196 Slip count on ports 2 and 3 set to 4
BpvErr, Port[2-3], Clr, COML 197 Clear BPV accumulated error count
RefFlt, Port[2-3], Off, COML 198 Reference Fault Strategy for CTA Action
disabled
Circuit ID, Set 199 Port Circuit ID set
Err Delay, (0), 10 sec, COML 251 An alarm delay time change
Alm Level, (1), Min, COML 252 An alarm level change
Setup, Factory, COML 254 User defaults have been set and saved
Table A-10. Output Module Event Messages
Event Message
Event #
Event Description
Install, Output Module\ 129 Module Installation
Remove, Output Module\ 130 Module Removal
Enable, Output Module, COML\ 131 Output module has been enabled
Disable, Output Module, COML\ 132 Output module has been disabled
Restart, in 5 seconds, COML\ 133 Module re-boot
Cannot Enable, Output Module, COML\ 144 Output module cannot be enabled
Frame Mode, ESF, COML\ 193 Output framing type change
ZS, On, COML\ 194 User changed output framing type
DS1 LEN, [0-5], len=133 ft., COML\ 195 User changed output line length (DS1 only)
CRC, On, COML\ 199 User has changed output framing type
SSM Bit, 8, COML\ 201 User has changed output SSM bit position
(E1 only)
Min Clk Level, ACQ, COML\ 202 User has changed Minimum Clock Level to
turn on outputs
Bypass, On, COML\ 203 User has changed Bypass mode of
operation
DutyCycle, Port= [0-1], 50/50, COML\ 204 CC signal duty cycle settings have been
changed for the port shown
Delay, Port= [0-3], 4000ft, COML\ 205 CC signal phase offset settings have been
changed for the port shown
Table A-9. LRM Event Messages (Continued)
Event Message Event # Event Description
To Next Page
Loading...
Need help?
General
