12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 427
Line Retiming Module Default Settings
Line Retiming Module Default Settings
Table E-8 lists settings and factory defaults for the Line Re-timing Module.
PQL 2 1 to 16
Disabled SV list Not applicable Up to 31 SV numbers
Min PDOP for position 3 1 to 10
Table E-8. Line Re-timing Module Configuration
Configuration Setting
Factory
Default
Range
Slips Threshold Error = 4,
Clear <4
1 to 255 (in any 24 hour period)
Fault Strategy AIS AIS
SQUELCH
Port Enable Enabled Enabled
Disabled
Port LBO 1 (0-133 ft) 1 = 0–133 ft
2 = 133–266 ft
3 = 266–399 ft
4 = 399–533 ft
5 = 533–655 ft
Circuit ID None (blank) String from 0-43 characters (only valid TL1 characters
are supported)
Table E-7. GPS Input Module Default Configuration (Continued)Settings
Configuration Setting Factory Default Range
To Next Page
Loading...
Need help?
General
