Provisioning and Operating the SSU-2000
Adding Users to the System
92 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
Adding Users to the System
Only an administrator-level user can add new users to the SSU-2000 user list.
Perform the following steps to add a user:
1. Connect a computer to the SSU-2000 using the procedure in Establishing a
Connection With the SSU-2000, on page 88. The
SSU-2000> prompt appears.
2. Type
login followed by the administrator’s user name and press Enter. The
system prompts for a password.
3. Type the administrator’s password and press Enter. The system prompt appears.
4. Type
user add and press Enter. The system prompts for the new username.
5. Enter the new username and press Enter. The system prompts for the new
user’s password.
6. Enter the new user’s password and press Enter. The system prompts for an
access level.
7. Enter the appropriate access level (0 through 4) and press Enter. Refer to
Overview of the SSU-2000 Security System, on page 98, for more information.
8. Type
bye and press Enter to log off the system.
9. Log back in using the new user’s username and password to verify that the
account exists.
10.Type
bye and press Enter to log off the system.
Initial Provisioning
After you have established communications with the SSU-2000, you must provision
the unit so it can track the input signals and start generating outputs. This sections
contains general instructions for initial provisioning of the SSU-2000, and are not
intended to cover all combinations of Input and Output modules. You may need to
alter the commands in this section to match the configuration of your SSU-2000.
Provisioning General Parameters
This section describes how to provision the reference mode and the auto-return
mode, set the IP address, and name the unit.
To Next Page
Loading...
Need help?
General
