Event Messages
254 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
Event Messages
Table A-6 lists event messages categorized by module. Each section lists status
messages associated with each module and an event description of each message.
Table A-6. Clock Module Event Messages
Event Message Event # Event Description
Install, Clock Module 129 Module installation
Remove, Clock Module 130 Module removal
Enable, Clock Module, COML\ 131 Module enabled
Disable, Clock Module, COML\ 132 Module disabled
Restart, in 5 seconds, COML\ 133 User requesting for a module to reboot
Cannot Enable, Clock Module, COML\ 134 Inability to enable module
Clk Select 144 Which clock module is selected to generate
output
Software phase lock loop
(Soft PLL, Acquire/Lock/Hold)
145 Software Phase Lock Loop in Acquire, Lock,
or Holdover status
Inp Select, 1A04-02\ 146 An Input has been selected as Reference
Output Pql, 2
(PQL value 1 to 5 ST2, or 8 ST3)
147 The Output PQL has been set to the value
shown
CLK C Sel, 1A04-02\ 148 A reference Input has been selected as an
output source
Warmup Chg, 1800 sec, COML\ 194 The user has changed the Oscillator
warmup time setting
Start tc, 240, COML\ 195 The user has changed the Starting Time
Constant (TAU) of the Oscillator
Dflt tc, 10000, COML\ 196 The user has changed the Default Time
Constant (TAU) of the Oscillator
Clk AR< On, COML\ 199 The user has changed the Clock
Auto-Return (ON | OFF)
Inp Switch, AR On, COML\ 200 The user has changed Input Auto-Return
(ON | OFF)
LO, Dis, COML\ 201 The user has changed the Local Oscillator
Output (ON | OFF) on the LO Output
connector
Inp Sel Mode, PQL, COML\ 202 Reference selection mode (Priority Quality
Level – PQL)
To Next Page
Loading...
Need help?
General
