12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 255
Event Messages
Err Delay, (1), 300 sec, COML\ 251 The user has changed Alarm Delay time
Alm Level, (2), Maj, COML\ 252 The user has changed Alarm level
(IGNORE, REPORT, MINOR, MAJOR,
CRITICAL)
Elevate Time, 7200 sec, COML\ 253 The user has changed alarm elevation time
change
Setup, User Default, COML\ 254 The user has set the module’s configuration
Table A-7. Communications Module Event Messages
Event Message Event # Event Description
KeepAlive, SSU2000 105 The Keep Alive function has been enabled/
disabled
Install, Comms Module\ 129 Module installation
Remove, Comms Module\ 130 Module removal
Enable, Comms Module, COML\ 131 The Comms module has been enabled
Disable, Comms Module, COML\ 132 The Comms module has been disabled
Restart, in 5 seconds, COML\ 133 Module reboot (Warm boot)
Log In, JAY, COML, level: 2\ 144 User at indicated level has logged in on
indicated port
Log Out, JOHN, COML, level: 2\ 145 User at indicated level has logged out from
indicated port
Auto Out, SMITH, COML, level: 3:\ 146 System automatically logging out a user
Msg, <HELLO USER>, COML\ 147 Message sent from a user
Not Acknowledged, 1A01\ 148 Module configuration could not be obtained
Module Status, Bad, 1A04\ 150 Module did not boot properly
UTC TIME, Valid/Invalid 151 Time of startup, when NTP is enabled but
GPS time is not being used
TODSYNC, TIMEOUT 152 Time of day (TOD) was requested by the
Comms module, no response from the GPS
module
Upgrade Image, Start/Complete 153 System firmware upgrade was started or
completed
Upgrade, 1A01 154 Module’s firmware upgrade has started
Table A-6. Clock Module Event Messages (Continued)
Event Message Event # Event Description
To Next Page
Loading...
Need help?
General
