12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 101
Provisioning and Operating the SSU-2000
Restoring Factory Defaults
3. Use the commands listed in TL1 Command Interface, on page 266, or Interactive
Command Set, on page 315, to configure the system.
4. Type
setup save and press Enter to save the current configuration as the user
default setting.
5. Type
bye and press Enter to log off the system.
Restoring Factory Defaults
Use the following procedure to reset the configuration to the factory default.
1. Connect a computer to the SSU-2000 using the procedure in Establishing a
Connection With the SSU-2000, on page 88. The
SSU-2000> prompt appears.
2. Log in to the SSU-2000:
ICS command:
Type
login followed by the administrator’s user name and press Enter. The
system prompts for a password. Type the administrator’s password and press
Enter. The system prompt
SSU-2000> appears.
TL1 command:
Type
ACT-USER::uid:123::pwd; where uid and pwd are the administrator’s
user id and password, respectively; 123 is an arbitrary ctag value.
3. Type
setup xAy factory and press Enter.
4. Type
bye and press Enter to log off the system.
Recommendation: Do not perform any command whose function
you do not understand. This could result in improper provisioning of
the network.
To Next Page
Loading...
Need help?
General
