TL1 Command Interface
276 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
RTRV-CONF:[tid]:[aid]:ctag;
Valid aid code: ALL, SxAy
This command returns the configuration (inventory
management) information for the addressed module(s). The
response is the complied message followed by the response
message(s). For an aid of ALL a one line summary for each
module is returned in the following format:
^^^"aid:status[,desc,item,rev,serial]" <cr lf>
where:
status
= configuration status {OK|BAD|RMVD|EMPTY}
The additional fields are present only if status = OK
desc = text name of the module
item = Item Number
rev = hardware revision level
serial = item serial number
If an aid is used in the command and the status is OK, then
two or more additional message lines are returned with the
following format:
^^^"aid:svcdat,svctim,mandat,”\userdat\”" <cr lf>
^^^"aid:cnt,\”revstr\” " <cr lf>
where:
svcdat = in-service date for the module, in the format
YY-MM-DD (year, month, day)
svctim = in-service time, as determined from when the
module was installed in the system, in the format
HH-MM-SS (hours, minutes, seconds)
mandat = manufacture date of YY-MM-DD reported by
the module
userdat = any additional information entered for the
module in a text string
Successive lines contain these fields:
cnt = software version count (from 0 to 5)
revstr = revision string returned by the module,
generally as X.yy [YY-MM-DD], where:
X = major revision number
yy = minor revision
date (optional) = the date the version was created, if
available
If no additional software is registered on the module, there
are no software revision lines present.
Table B-5. TL1 Retrieve Commands (Continued)
Command Description
To Next Page
Loading...
Need help?
General
