TL1 Command Interface
286 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
RTRV-EVENT-ALARM:[tid]:[aid]:
ctag::[count],[start],[stop];
Valid aid code: ALL, SxAy
This command returns only alarm information from the
stored event data.
The format for event log reports is:
^^^"aid:ntfcncde,condtype,srveff,ocrdat,ocrtm:
condscr" <cr lf>
where:
ntfcncde = Notification Code (CR, MJ, MN, CL)
condtype = Condition Type (event number)
srveff = service affecting flag (SA, NSA)
ocrdat occurrence date
ocrtm = occurrence time
condstr = condition description string
start = start time specifies the start date and time for
data in the format MM-DD,HH-MM. If the date is null but
followed by a time, the command defaults to the current
date. If the start time is null, but preceded by a date, the
command defaults to the current time. If the start date
and time are null, the command defaults to the start of the
data. The comma must be present to indicate a null start
time.
stop = stop time specifies the stop date and time for data
in the format MM-DD,HH-MM. If the date is null but
followed by a time, the command defaults to the current
date. If the stop time is null but preceded by a date, the
command defaults to the current time. If the stop date
and time is null, the command defaults to the end of the
data.
RTRV-EVENT-REPORT:[tid]:[aid]:
ctag::[count],[start],[stop];
Valid aid code: ALL, SxAy
This command returns only reports (non-alarm) information
from the stored event data. These have a ntfcncde of NA.
The format for event log reports is:
^^^"aid:ntfcncde,condtype,srveff,ocrdat,ocrtm:
condscr" <cr lf>
where:
ntfcncde = Notification Code (NA)
condtype = Condition Type (event number)
srveff = service affecting flag (SA, NSA)
ocrdat = occurrence date
ocrtm = occurrence time
condstr = condition description string
start = the start time
stop = the stop time
Table B-5. TL1 Retrieve Commands (Continued)
Command Description
To Next Page
Loading...
Need help?
General
