Interactive Command Set
354 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
NAME
Use this command to view and set the unit name.
Level 0 Not applicable
Level 1
NAME
Use this command to display the unit name.
Level 2 Same as Level 1 operation
Level 3
NAME unit_name
Sets the current unit name. You can use up to 20 characters for the
unit name. This name is for identification purposes only.
Level 4 Same as Level 3 operation
Remarks The name displays as part of the prompt
Related Valid names must start with a letter. If TL1 is to be used, care must
be taken in the assignment of the unit name as it is the Target
Identification (TID) for that mode.
Restrictions None
To Next Page
Loading...
Need help?
General
