Interactive Command Set
378 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
USERS
Use this command to access the user list.
Level 0 Not applicable
Level 1
USERS
USERS [MODIFY]
Options are:
MODIFY This option changes the user’s password. This does not
allow for change of user name or access level.
If this option is not provided, valid user names and their
associated access levels display.
Level 2 Same as Level 1 operation
Level 3 Same as Level 2 operation
Level 4 Same as Level 3 operation, with the following additions:
USERS INITUSERTABLE
USERS [{ADD|MODIFY|DELETE}]
USERS LOGOFF commport
Options are:
INITUSERTABLE
Use this option to clear the user table and leave only
the built-in (default) system users. This option requires
users to confirm their intention to clear the user table by
entering the complete INITUSRTABLE command.
ADD Use this option to add a user to the system. If the user
exists in the system, this option exits with an error. After
the user ID is entered, you are prompted for a
password. Password entries are echoed as ‘*’. Valid
password characters are upper case, alphanumeric
characters. After you enter the password, you are
prompted for the user level (1 through 4).
MODIFY Use this option to modify the password and access
level for a user. If the user ID is not in the system, this
command exits with an error. After you enter the user,
this option performs identically to the ADD option.
DELETE Use this option to delete the user from the SSU-2000. If
the user ID is not in the system, this command exits
with an error.
To Next Page
Loading...
Need help?
General
