SYSMEX XP Series - Initial Operation; Introduction

Sysmex XP-300 5-1
Initial Operation
Revised July 2012
5. Initial Operation
5.1 Introduction
This product is an In-vitro diagnostic medical device.
A Sysmex service representative is responsible for unpacking,
installing, and initial setup of the product to ensure its proper and
safe operation.
The next several pages will give some essential information on this
instrument.
In case relocation becomes necessary after installation, contact your
Sysmex service representative.
Pay careful attention to this because if relocation, etc. of the
instrument is conducted by the customer, issue occuring as a result
will not be covered under warranty even within the warranty period.
Note:
When the connection of a graphic printer (option) to this
instrument is intended, contact your Sysmex service
representative.