SYSMEX XP Series - External Output

Sysmex XP-300 9-27
Quality Control
Revised May 2012
Printing control chart
(1) Press the [Out/Del] button in the quality control chart screen.
The output/delete menu dialog will appear.
(2) Select the output destination button from the internal printer
(IP), graphic printer (GP) or list printer (LP).
• [Current]: Prints out the data at the cursor position in the
control quality printing format.
• [Chart]: Prints out control charts of all parameters.
• [All]: Prints out all plot data of the file being displayed
(up to 60 plots).
• [Cancel]: Closes the output/delete menu dialog.
External output
(1) Press the [Out/Del] button in the quality control chart screen.
The output/delete menu dialog will appear.
(2) Press the [Current] button next to “HC”.
The data at the cursor position is output to the host computer in
the quality control output format. It is possible to output to
either the serial port (RS-232C) or LAN (Ethernet), depending
on the user setting.
Note:
• The output/delete menu dialog buttons are valid only for
output destination buttons set in [Printer] in the Settings
menu.
• User settings can also be made for automatic output.
(See “Printer” in “11.2 Possible settings”.)
• While this dialog appears on the LCD, other buttons outside
the dialog are not operative.
Note:
• User settings can also be made for automatic output.
(See “Host Output” in “11.2 Possible settings”.)
• When no setting is made to output to the host computer, the
[Current] button next to “HC” becomes invalid.