Analyzing waveforms Set up Custom search parameters
Set up Custom search parameters
Aftersettingupacustombus,gototheAnalyzemenu,select Search, and then select the Bus t rigger type;
then open the Configure tab.
Overview
Use the cont
rols to s et up the Custom Bus parameters.
To use
For information on the controls, click the buttons.
Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown
above. These controls vary depending on the search Type. Setting the search conditions is similar to
setting the parameters for an Event Trigger
(see page 386).
NOTE. No information will be displayed in this window until you specify at least one search Type in
the Search Select Control Window
(see page 300).
To use
Click the Source box and select the bus number or name from the window. Bus Search Selection
List (see page 98)
Select the type of bus cycle or a ctivity to search for from the Search For drop-down list.
For some Search For selections, you must set additional fields to define other p arameters.
What do you want to do next?
368 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
Need help?
General
