www.trilithic.com
Page II-69
180 DSP Operation Manual
Signal Level Meter
Save an Open Limit Set
After editing an open limit set, you must
save your changes.
Perform the following steps to save the
limit set:
1. Select the File softkey.
2. From the File pop-up menu, select
the Save button as shown in the
image to the right.
3. The limit set will be saved to the
internal memory of the 180 DSP.
Save an Open Limit Set with a New Name
After editing an open limit set, you can save the limit set with a new name. This function is
useful for duplicating an existing limit set.
Perform the following steps to save the limit set with a new name:
1. Select the File softkey.
2. From the File pop-up menu, select
the Save As button as shown in
the image to the right.
3. Use the Virtual Keyboard to enter
the new name for the limit set as
shown in the image to the right.
4. The new limit set will be saved to
the internal memory of the 180
DSP.
To Next Page
Loading...
Need help?
General
