www.trilithic.com
Page II-83
180 DSP Operation Manual
Signal Level Meter
Restore from USB Flash Drive
Perform the following steps to restore the 180 DSP database le from a USB ash drive:
1. Insert a USB ash drive into the
USB Port of the 180 DSP.
2. Press the Function button and
select the Activate USB Power
function as shown in the image to
the right.
3. The power to the USB ash drive
is activated and the drive is now
mounted to the îš¿le system as
shown in the image to the right.
The 180 DSP is now capable of
transferring îš¿les to and from the
USB ash drive.
4. Select the Database softkey.
5. From the Database pop-up menu,
select the Restore button as
shown in the image to the right.
6. The entire database will be
restored from the USB ash drive.
To Next Page
Loading...
Need help?
General
