www.trilithic.com
Page II-30
180 DSP Operation Manual
Signal Level Meter
Keypad Rate
The Keypad Rate setting is used to
adjust the keypad rate.
The default setting for the keypad rate is
50 mSeconds. The keypad rate can be
set from a minimum of 50 mSeconds up
to a maximum of 1000 mSeconds.
Use either of the following methods to
change the keypad rate:
• Use the up/down arrow buttons to
change the value in 50 mSecond
increments.
• Press the Enter button and use
the Virtual Keyboard to directly
enter the keypad rate as shown in
the image to the right.
To Next Page
Loading...
