www.trilithic.com
Page I-34
180 DSP Operation Manual
Signal Level Meter
Toggle Flashlight
This function is used to toggle the ashlight
on and off. To turn the LED ashlight on,
select the Toggle Flashlight button from the
Function menu as shown in the image to the
right.
The LED ash light will illuminate until the
ashlight delay has expired (between 30 and
180 seconds, user adjustable) or it has been
manually toggled off.
To manually toggle the LED ash light off,
press the Function button and then select the Toggle Flashlight function again.
To adjust the Flashlight Delay, see Section II: Setup, Chapter 3:
Meter Conguration, Interface Settings.
To Next Page
Loading...
