www.trilithic.com
Page II-27
180 DSP Operation Manual
Signal Level Meter
Turn Off Delay
The Turn Off Delay setting is used to
conserve power by automatically turning
off the device after the 180 DSP has
been idle for a speciîš¿ed period of time.
The default setting for the turn off delay
is 1 Hour. The turn off delay can be set
from a minimum of one (1) hour up to a
maximum of 24 hours.
Use either of the following methods to
change the turn off delay:
• Use the up/down arrow buttons to
change the value in one (1) hour
increments.
• Press the Enter button and use
the Virtual Keyboard to directly
enter the turn off delay as shown
in the image to the right.
To Next Page
Loading...
Need help?
General
