www.trilithic.com
Page II-15
180 DSP Operation Manual
Signal Level Meter
Operating Level
The Operator Level setting is used to
control whether the 180 DSP is operating
in its normal mode or in an advanced
logging mode. The logging mode is used
for advanced troubleshooting by Trilithic
technical support.
The default setting for Operator Level is
Normal, use the up/down arrow buttons
to select from the following preset values:
• Select Normal for the normal mode
of operation.
• Select Logging for troubleshooting with Trilithic technical support.
• Select Calibrate to enter the calibration mode.
Multiple User Control
The Multiple Users setting is used to
control whether multiple user proles are
displayed when the 180 DSP is powered
on.
The default setting for Multiple Users is
Yes, use the up/down arrow buttons to
select from the following preset values:
• Select Yes to allow multiple user
proles.
• Select No to use only one user prole.