www.trilithic.com
Page II-31
180 DSP Operation Manual
Signal Level Meter
Distance Units
The Distance Units setting is used to set
the default distance measurement units to
display on the 180 DSP.
The default setting for Distance Units is
Meters, use the up/down arrow buttons to
select from the following preset values:
• Feet
• Meters
Temperature Units
The Temperature Units setting is used
to set the default temperature units to
display on the 180 DSP.
The default setting for Temperature
Units is Celsius, use the up/down arrow
buttons to select from the following preset
values:
• Fahrenheit (°F)
• Celsius (°C)
To Next Page
Loading...
