www.trilithic.com
Page II-29
180 DSP Operation Manual
Signal Level Meter
Keypad Delay
The Keypad Delay setting is used to
adjust the keypad delay.
The default setting for the keypad delay
is 300 mSeconds. The keypad delay
can be set from a minimum of 100
mSeconds up to a maximum of 1000
mSeconds.
Use either of the following methods to
change the keypad delay:
• Use the up/down arrow buttons to
change the value in 50 mSecond
increments.
• Press the Enter button and use
the Virtual Keyboard to directly
enter the keypad delay as shown
in the image to the right.
To Next Page
Loading...
Need help?
General
