www.trilithic.com
Page IV-131
180 DSP Operation Manual
Signal Level Meter
Ping Mode
When the Ping mode is selected, the
following measurement results are
displayed as shown in the image to the
right:
• Minimum Time - This is the
minimum time required to send/
receive a single test packet.
• Average Time - This is the average
time required to send/receive all
test packets.
• Maximum Time - This is the maximum time required to send/receive a single test
packet.
• Sent - This is the number of packets sent by the 180 DSP to the destination IP
address.
• Received - This is the number of packets received by the 180 DSP from the
destination IP address.
• LPR - This is the lost packet ratio. This measurement is displayed in the bar graph
and as a numeric value. The LPR is calculated as the percentage of packets
received to those which were sent (LPR = {Received Packets / Sent Packets} *
100%), for example:
• 50 sent packets
• 25 received packets
• LPR = {25 / 50} * 100%
{0.50} * 100%
50%
To Next Page
Loading...
