www.trilithic.com
Page IV-135
180 DSP Operation Manual
Signal Level Meter
Traceroute
When the Traceroute mode is selected,
the following measurement results are
displayed as shown in the image to the
right:
• Hop – This is the number of the
intermediary point (hop) in the
route between the meter and the
destination address.
• Address – This is the IP address
of the corresponding intermediary
point (hop).
• Name – This is the name of the corresponding intermediary point (hop).
• Time – This is the time to each intermediary point (hop).
To Next Page
Loading...
