www.trilithic.com
Page I-23
180 DSP Operation Manual
Signal Level Meter
Basic Navigation & Control
Startup
Once the instrument’s battery is charged,
you may startup the 180 DSP by pressing
the Power button at the bottom left of the
keypad.
Upon startup one of the following will
occur:
• If multiple user proles are
activated, the instrument will
display the Welcome to the 180
DSP screen as shown in the
image above. Use the touchscreen
or keypad to select the user
proîš¿le that you wish to use. The
Troubleshoot menu will be
displayed as shown in the image to
the right.
• If multiple user proles are
deactivated, the 180 DSP
will automatically display the
Troubleshoot menu as shown in
the image to the right.
For more information about conîš¿guring multiple user proîš¿les,
see Section II: Setup, Chapter 3: Meter Conîš¿guration, Global
Settings.
For more information on how to log off the current user or to
switch to another user, see Chapter 4: Function Menu, Log Off
User later in this section.
To Next Page
Loading...
Need help?
General
