Wittenborg FB 5100 - Data Input; Data Output; Data Retrieval And;Or Programming

25
Data retrieval and/or programming
Data output Data can be retrieved from the machine by using
• service mode (programming mode) of the machine using the selection
buttons of the selection panel (audit and settings data can be read out)
• PC or terminal (plug connection to P12 on VMC only in VIDTS format)
(settings data can be read out)
• hand-held terminal (data carrier) using a PDC in connection with the
MID kit, this connection is available via the optical interface on the out-
side of the door (audit data can be read out)
Data input Data can be programmed into the machine by using
• service mode (programming mode) of the machine using the selection
buttons of the selection panel (settings data can be read in)
• PC or terminal (plug connection to P12 on VMC only in VIDTS format)
(settings data can be read in)