Wittenborg FB 5100 - Installation of the Vending Machine; Mounting

2
Installation of the vending machine
Only trained service technicians should carry through the installation of
the vending machine!
Mounting
Step Action
1.
Unpack the vending machine and check it for damage.
2.
Set the machine up. Adjust the horizontal and vertical position by means of
the base setting screws.
3.
Open the door.
4.
Remove the instant canisters and the dosing system.
5.
Remove the mounting kits.
6.
Unpack the instant ingredient canisters.
7.
Fill the FB canister or the ES coffee bean canister.
8.
Fill the instant ingredient canisters.
9.
Unpack the waste bucket and place in position.
10.
• Remove the colour panel: Open door, loosen upper and lower screws,
and lift off colour panel.
• Slide the "button panel" with the price label to the side.
• Remove the price label from the "button panel". Enter the prices accord-
ing to the requirement of the customer on the label by blackening the
bars that are not needed.
• Reinsert the price label into the guides of the "button panel" (do not lose
the transparent cover for the price label).
• Slide the "button panel" with the price label into the appropriate guides
in the selection panel.
• Lift on the colour panel again and retighten screws.