NOTICE!
Malfunctions due to insu󰂤cient protection against electromagnetic
interference
Exposure electromagnetic interference may cause malfunctions or incorrect internal
readings.
• Install an EMI 󰈡lter (i.e. SCHAFFNER - FN 2070-3-06) for the power supply inputs
when using the control unit in marine applications.
Some additional, independent safety and protection devices are necessary to meet
safety requirements of Rules and Regulations of marine Classi󰈡cation Societies.
• Please refer to the corresponding documents issued by marine Classi󰈡cation
Societies for the applicable requirements.
1.4.4
Protective Equipment And Tools
Protective gear
Personal protective equipment serves to protect risks to the safety and health of persons
as well as to protect delicate components during work.
Certain tasks presented in this manual require the personnel to wear protective
equipment. Speci󰈡c required equipment is listed in each individual set of instructions.
The cumulative required personal protective equipment is detailed below:
Protective equipment: ESD wrist band
The ESD (electrostatic discharge) wrist band keeps the user's body set to ground
potential. This measure protects sensitive electronic components from damage due to
electrostatic discharge.
Tools
Use of the proper tools ensures successful and safe execution of tasks presented in this
manual.
Speci󰈡c required tools are listed in each individual set of instructions.
The cumulative required tools are detailed below:
Special tool: Torque screwdriver
A torque-screwdriver allow fastening of screws to a precisely speci󰈡ed torque.
• Note the required torque range individually speci󰈡ed in the tasks listed in this
manual.
22 LS-5 v2 Series 37650
1 General Information
1.4 Safety
To Next Page
Loading...
Need help?
General
