Woodward LS-5 v2 Series - Setup Connections; Terminal Allocation

Tighten the screws with a crosswise pattern to ensure even pressure
distribution.
If the thickness of the panel sheet exceeds 2.5 mm, be sure to use screws
with a length exceeding the panel sheet thickness by 4 mm.
3.3 Setup Connections
General notes
NOTICE!
Malfunctions due to literal use of example values
All technical data and ratings indicated in this chapter are merely listed as examples.
Literal use of these values does not take into account all actual speci󰈡cations of the
control unit as delivered.
• For de󰈡nite values please refer to chapter ╚═▷ “8 Technical Speci󰈡cations”.
Wire sizes
AWG mm² AWG mm² AWG mm² AWG mm² AWG mm² AWG mm²
30 0.05 21 0.38 14 2.5 4 25 3/0 95 600MCM 300
28 0.08 20 0.5 12 4 2 35 4/0 120 750MCM 400
26 0.14 18 0.75 10 6 1 50 300MCM 150 1000MCM 500
24 0.25 17 1.0 8 10 1/0 55 350MCM 185
22 0.34 16 1.5 6 16 2/0 70 500MCM 240
Tab. 3: Conversion chart - wire sizes
3.3.1 Terminal Allocation
General notes
The device terminals are allocated as follows:
• Plastic housing - shown in ╚═▷ Fig. 18
• Sheet metal housing - shown in ╚═▷ Fig. 19
38 LS-5 v2 Series 37650
3 Installation
3.3 Setup Connections
Released