USER GUIDE (PRINT)
2–63
U
SER
G
UIDE
(P
RINT
)
B. Basic Printing
Paper
This section describes the differences of the paper to be used for
printing on this machine. Other than these, there is no difference
on using paper for copying and printing.
For more information on how to load paper, refer to the User
Guide (Copier).
Differences From Copying
Tray 5 (Bypass Tray) When using Tray 5 (Bypass Tray), there is a restriction on the
orientation of loading paper.
When printing with Tray 5 (Bypass Tray), be sure to select Tray 5
(Bypass Tray) from the Paper Source menu on the Tray/Output
tab, and then select the correct paper type from the Paper Tray
(Bypass Tray) menu on the print driver screen.
• Refer to on-line Help of the print driver for details on
printing special papers like transparencies.
• For details on loading paper in Tray 5 (Bypass Tray), refer
to the User Guide (Copier).
Caution for Printing If the paper size or type used for printing is different from the
selection on the print driver, or if the paper is loaded in an
unsuitable paper tray, it may cause paper to jam.
Automatic Tray Switching To enable the Auto Tray Switch feature, Auto must be selected
from the Paper Source menu on the Tray/Output tab.
NOTE: The Auto Tray Switch feature is displayed as Disable Auto
Tray Switch in the Common Menu and Internet Services.
Outputting Paper To use the Job Offset feature you must first configure the setting
on the Configuration tab of the print driver. Refer to on-line Help of
the print driver for details.
To Next Page
Loading...
Need help?
General
