1–40
U
SER
G
UIDE
(C
OPIER
)
Border Erase
The Border Erase feature enables you to eliminate unwanted
marks near the edges of the original from the output copy. The
range for Border Erase is 0 through 50mm in 1mm increments.
Border Erase offers the following options which can be used
individually or combined together:
Top & Bottom The default is 5mm.
Left & Right The default is 5mm.
Center The default is 5mm.
The selected settings are applied to both the front and back of 2-
sided copies.
When the image is reduced or enlarged, the selected percentage
will be applied to the Border Erase. For example, a 50% reduction
will reduce 30mm when a 15mm Border Erase is set.
When making copies the copier always automatically adds an
Border Erase of 2mm to the top, bottom, left and right. This
cannot be eliminated.
1
On the Added Features tab select Border Erase.
2
Select Variable Erase.
3
Press the up or down arrows to increase or decrease the Border
Erase amount(s) for Top & Bottom, Left & Right, and Center.
4
Select the icon that most closely resembles the Original
Orientation for the loaded document(s).
5
Select Start to make copies or Save to select additional features.
To Next Page
Loading...
Need help?
General
