Xerox DocuColor 2240 User Manual

1–30
U
SER
G
UIDE
(C
OPIER
)
Programming the Paper Supply for Tray 5 (Bypass)
You must select the paper size and paper type when loading
paper into Tray 5 (Bypass). Auto Size Detect can be used with
standard size paper.
1
On the Basic Copying tab select More… under Paper Supply.
2
Select Tray 5 (Bypass) to display the Tray 5 (Bypass) screen.
3
Perform one of the following to select Paper Size:
•Select Auto Size Detect.
•Select Standard Size.
• Select the paper size from the list. Use the up and down
arrows to see more selections.
•Select Non-standard Size and enter in the X (width) and Y
(length) dimensions by using the arrows.
• Press the left or right arrows to decrease or increase the X
dimension (140-483mm).
• Press the up or down arrows to increase or decrease the Y
dimension (100-305mm).
4
Select the appropriate Paper Type using the up and down arrow
buttons. You can select Plain, Bond, Recycled, Transparency, and
Lightweight - Extra Heavyweight paper.
5
Select Save to return to the Paper Supply screen.
6
Select Start to make copies or Save to select additional features.
NOTE:Paper Tray 5 cannot be used with the following features: 1
to 2-Sided, 2 to 2-Sided, Auto Reduction/Enlargement, Auto
Center, Corner Shift, Negative Image, Mirror Image, Book Duplex,
Booklet Creation, Multiple Up, Repeat Image, Bound Originals
and Poster.

Xerox DocuColor 2240 Specifications

General

Brand	Xerox
Model	DocuColor 2240
Category	All in One Printer
Language	English