USER GUIDE (COPIER)
1–9
U
SER
G
UIDE
(C
OPIER
)
Paper Trays
Trays 1,2,3 and 4 are located at the lower front of the copier/
printer. Tray 5 (Bypass) is located on the left side of the copier/
printer.
Trays 1 and 2 Adjustable from 5.5x8.5 in. through 11x17 in. (A5 through A3), and
can accommodate up to 520 sheets based on paper weight.
Trays 3 and 4 High capacity paper trays accommodating a total of 2000 sheets,
8.5x11 in. (A4 and B5) based on paper weight.
Tray 5 (Bypass) Feeds specialty papers i.e. Transparencies, Extra Heavyweight
and non-standard sizes and 12x18 in.
Trays 1 - 4 can feed paper weights 64 to 105 gsm. The machine
automatically detects the size and orientation of loaded paper.
The paper type however must be set on the control panel. Bond
paper is the default setting, plain or recycled paper in trays must
be identified on the control panel for maximum efficiency and
image quality. This is set in System Settings mode.
Output Trays
The Center Output Tray delivers output face down, and holds up
to 400 sheets. The Center Output Tray holds up to 200 sheets
when the Finisher (optional accessory) is installed.
The Finisher Tray (optional accessory) holds up to 1000 sheets,
and can staple dual and single staples.
NOTE: The DocuColor copier/printer should not be moved after it
has been installed. Moving may damage the equipment, carpet or
floor. If equipment must be moved, please contact your Xerox
representative for assistance.
To Next Page
Loading...
Need help?
General
