USER GUIDE (MACHINE
ADMINISTRATOR)
4–41
U
SER
G
UIDE
(M
ACHINE
A
DMINISTRATOR
)
Receiving Buffer-LPD
Spool
Choose from the following options:
• Off - Spooling is not performed.
While the machine is processing or printing LPD data from a
client, it cannot receive other data from other clients through
the same interface. The LPD reception buffer can be set
between 64 ~ 1024 KB, in increments of 32 KB. The default is
256 KB.
• Memory - Spooling is performed.
Memory is used as the reception buffer for the spooling
process. The size of the reception buffer for the spooling
process can be set between 512 KB ~ 32.00 MB, in
increments of 0.25 MB. The default is 1.00 MB.
NOTE:Printing data bigger than the memory size set here cannot
be received. If this happens, select Hard Disk Spooling or
Spooling Off.
• Hard Disk - Spooling is performed.
Hard drive is used as the reception buffer for the spooling
process.
The default is Off.
Receiving Buffer-NetWare Set the reception buffer for NetWare.
The memory size can be set between 64 ~ 1024 KB, in increments
of 32 KB. The default is 256 KB.
Receiving Buffer-SMB
Spool
Choose from the following options:
• Off - Spooling is not performed.
While the machine is processing or printing SMB data from a
client, it cannot receive other data from other clients through
the same interface. The SMB reception buffer can be set for
64 ~ 1024 KB, in increments of 32 KB. The default is 256 KB.
• Memory - Spooling is performed.
Memory is used as the reception buffer for the spooling
process. The size of the reception buffer can be set between
512 KB ~ 32.00 MB, in increments of 0.25 MB. The default is
1.00 MB.
NOTE:Printing data bigger than the set memory size cannot be
received. If this happens, select Hard Disk Spooling or Spooling
Off.
• Hard Disk - Spooling is performed.
Hard drive is used as the reception buffer for the spooling
process.
The default is Off.
To Next Page
Loading...
Need help?
General
