Xerox Wide Format 6705 System

2
Copy
2.9 Running Sample Copies
94
Steps
St
1.
Press [Copy] on the [Services Home] screen.
2.
Press the [Output Format] tab.
3.
Press [Sample Copy].
4.
Press [Lighten / Darken List].
5.
Set [Scan Start Position] and [Measurement] as
necessary, and press [close].
Refer

"Sample Copy (Determining the Optimal
Settings Before Running the Whole Copy Job)"
(p. 121)
6.
Set other features as necessary.
7.
Load the document.
The sample copy with the specified settings applied is
output.
Note

To run another sample copy, repeat Steps 2. to 7..

Settings are not kept between sample copies. To run another sample copy, press [Sample Copy] again.
8.
Once you have determined which density is optimal for the document, change the setting for [Lighten /
Darken] appropriately.
9.
Press [Copy from Memory] and then press [Start].
The entire image with the specified settings applied is output.