WorkCentre 3210/3220 Multifunction Printer Service Manual 5-17
Print-Quality Troubleshooting
Ghosting (3)
There is ghosting at 62.8 mm or 77.6 mm intervals. Fuser operating
temperature is too high.
Initial Actions
■ Ensure there are no debris in the Fuser.
■ Verify the paper is within the printer specifications (refer to “Media and
Tray Specifications” on page 1-18).
Allow the Fuser to cool before starting the procedure.
Troubleshooting Reference Table
Applicable Parts Example Print
■ Fuser, PL8.0.0
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the Fuser.
Is there any contamination on the
Fuser?
Clean the Fuser. Replace the
Fuser (
8-13).
s3210mfp-205
GHOSTING
GHOSTING
GHOSTING
GHOSTING
62.8 or 77.6 mm
To Next Page
Loading...
