1-20 WorkCentre 3210/3220 Multifunction Printer Service Manual
General Information
Mounting Surface Specifications
These specifications apply to any printer used as a table-top printer.
1. In order to function properly, the printer must be placed on a surface with
the following minimum dimensions.
2. Mounting surface flatness must be within the specified range. The printer
must not be tipped or tilted more than 2 mm (0.08 inch).
Failure to adhere to the specified mounting specifications will void all
guarantees of print-quality and/or performance.
2 mm
(0.08 in.)
2 mm
(0.08 in.)
s3210mfp-083
To Next Page
Loading...
