July, 2007
6-15
WorkCentre 5020
General Procedures
Initial Issue
23 21 PH Feed Tray 1~6 1 O O O 1: Tray1. 2: Tray2. 3: Tray3. 4: Tray4.
5: HCF. 6: MSI
23 22 PH Output Tray 0~4 0 O O O 0: FACE DOWN TRAY#1.
1: FACE DOWN TRAY#2.
2: FACE UP TRAY.
3: FINISHER Bin1.
4: FINISHER Top Tray
23 26 PH Test Print Run Length Low
Byte
0~99 1 O O O Number of Test Prints
23 27 PH Test Print Run Length High
Byte
0~99 0 O O O Number of Test Prints
29 01 Billing Last 2 Dig Total Copy
Counter(8 Digits)
0~99 0 O X X
29 11 Billing 3rd & 4th Dig Total Copy
Counter(8 Digits)
0~99 0 O X X
29 21 Billing 1st 2 Dig Total Copy
Counter(8 Digits)
0~99 0 O X X
29 04 HFSI Tray1 Last 2 Digits of Feed
Capacity (8 Digits)
0~99 1 0 O O X Only 0 clearance is possible in the write
mode.
("0 clearance" means all bytes change to 0
at the same time.)
29 14 HFSI Tray1 5th & 6th Digits of Feed
Capacity (8 Digits)
0~99 1 0 O O X Only 0 clearance is possible in the write
mode.
("0 clearance" means all bytes change to 0
at the same time.)
29 24 HFSI Tray1 3rd & 4th Digits of
Feed Capacity (8 Digits)
0~99 1 0 O O X Only 0 clearance is possible in the write
mode.
("0 clearance" means all bytes change to 0
at the same time.)
29 34 HFSI Tray1 1st 2 Digits of Feed
Capacity (8 Digits)
0~3 1 0 O O X Only 0 clearance is possible in the write
mode.
("0 clearance" means all bytes change to 0
at the same time.)
Chain
Func
tion Sub Contents of Data Range Unit
Initial
Value
CE
Access
RemarksRWInit