July, 2007
6-36
WorkCentre 5020
Initial Issue
General Procedures
Noise (Sound Power Level: LWAd)
Unit: B
Impulse Sound Power (FX) Impulse Sound Power Level (LWAI)
LWAI B(A)
Chemical Substances
1. Levels of Ozone:
Ozone formed from this product: less than 0.02 mg/m3 (according to C11-705)
Eco-Mark Requirement: 0.02 mg/m3
2004 Version Green Target A Limit: 0.015 mg/m3
2. Airborne Dust Concentration:
Inhaled airborne dust from this product: less than 0.08 mg/m3 (according to C11-705)
Eco-Mark Requirement: 0.075 mg/m3
2004 Version Green Target A Limit: 0.04 mg/m3
Copy Speed
Continuous copy speed at 100% magnification.
Measurement method: Make 11 continuous copies. Measure the time (T, in seconds) from the
output of the trail edge of the first sheet of paper to the output of the trail edge of 11th sheet of
paper, and convert into copies per 60 seconds: CPM = T/60 (normal paper mode).
Alignment
1. Full system] IOT+IIT+ADF
2. [DC] IOT+IIT (TBD)
Table 14
Standby Mode Operation Mode
Base Machine 4.0 6.8
Full System 4.0 6.8
Table 15
Base Machine 6.6
Full system 7.1
Table 16
Paper Size
and
Paper Orientation
Paper Tray
Tray 1 STM (Add 1 Tray) MSI
Fixed Mode
Plain Paper Plain Paper
A4 LEF 20 20 10
8.5" x 11" LEF
16K LEF
B5 LEF
A4 SEF 15 15 10
8.5" x 11" SEF
16K SEF
B5 SEF
8.5"x13"SEF 8.5"x14"
SEF
12 12 10
Mexico Folio
(8.5" x13.4")
A3 SEF
11" x 17" SEF
10 10 10
8K SEF
B4 SEF
A5 SEF
5.5" ( 8.5" SEF)
Not supported 10
10
A5 LEF Not supported
5.5" x 8.5" LEF
Table 17
Item Specification Measurement Length
Skew H [mm] +/-2.3 200mm
Perpendicularity [mm] +/-3.7 400mm
Linearity: V [mm] 2.3 400mm
Linearity: H [mm] 2.3 280mm
Linearity: D [mm] 2.3 280mm
Registration: Lead [mm] +/-2.9
Registration: Side [mm] +/-3.4
Magnification: V (%) +/-1.4 (100%)
+/-1.56 (50%-99%)
+/-1.8 (101%-200%)
400mm
Magnification: H (%) +/-1.4 (100%)
+/-1.56 (50%-99%)
+/-1.8 (101%-200%)
280mm
Table 18
Item Specification Measurement Length
Simplex MSI
Skew H +/-2.0 +/-2.3 200mm
Perpendicularity +/-3.1 +/-3.3 400mm
Linearity: V 1.6 -- 400mm
Table 16
To Next Page
Loading...
