7-1
7
Advanced Operation
This chapter describes the user constants used for specific control methods
in VS-616G5 application.
7.1 Open-loop Vector Control 7 - 2...............
7.1.1 Torque Limit Function 7 - 4........................
7.1.2 Adjusting Speed Feedback 7 - 5...................
7.1.3 Setting/Adjusting Motor Constants 7 - 6.............
7.1.4 Operation Selection when Output Voltage
Saturated 7
-
8.................................
7.1.5 Starting Torque Compensation Function
(for SPEC:F) 7 - 9..............................
7.2 V/f Control without PG 7 - 11..................
7.2.1 Energy-saving Control Function 7 - 13...............
7.2.2 Hunting-prevention Function 7
-
13..................
7.2.3 Setting Motor Constants 7 - 14......................
7.3 Flux Vector Control 7 - 16....................
7.3.1 Droop Control Function 7
-
18.......................
7.3.2 Zero-servo Function 7
-
19..........................
7.3.3 Torque Control 7 - 21..............................
7.3.4 Speed/Torque Control Switching Function 7
-
27......
7.3.5 Torque Limit Function 7 - 30........................
7.3.6 Setting/Adjusting Motor Constants 7 - 31.............
7.3.7 Operation Selection when Output Voltage
Saturated 7 - 34.................................
7.4 V/f Control with PG 7 - 36.....................
7.4.1 Energy-saving Control Function 7 - 38................
7.4.2 Hunting-prevention Function 7 - 38...................
7.4.3 Setting Motor Constants 7 - 39.......................
7.5 Common Functions 7 - 41....................
7.5.1 Application Constants: b 7 - 43......................
7.5.2 Tuning Constants: C 7 - 52.........................
7.5.3 Reference Constants: d 7 - 57.......................
7.5.4 Option Constants: F 7 - 59..........................
7.5.5 External Terminal Functions: H 7 - 64................
7.5.6 Protective Functions: L 7 - 84.......................
7.5.7 Operator Constants: o 7 - 97........................
7
To Next Page
Loading...
Need help?
General