7.2 V/f Control without PG
7-15
J
Motor Iron−core Loss with Torque Compensation:E2-10 (for SPEC: F)
User
Change
Valid Access Levels
Constant
Number
Name
during
Opera-
tion
Setting
Range
Unit
Factory
Setting
V/f
Control
V/f with
PG
Open
Loop
Vector
Flux
Vector
E2-10
Motor iron−core loss
with torque com-
pensation
×
0 to 65535
W
14
A A
× ×
D
The default setting depends upon the Inverter capacity. The above table shows the settings for 200V
class, 0.4 kW Inverter. (See page:8 - 47)
D
The motor iron−core loss is set in “W” units.
D
Normally, the settings do not need to be altered. However, if the Inverter and motor capacities are vast-
ly different, set the E2-10 value for the same Inverter capacity as the applicable motor. (See page:
8 - 47)
7
To Next Page
Loading...
Need help?
General