YASKAWA CIMR-G5A Series - Page 157

7.1 Open-loop Vector Control
7-3
Group
Control Meth-
od
CommentsFunction
Group
Flux Vector
Open-loop Vector
V/f w/PG
V/f
CommentsFunction
L1 Motor Protection Functions
Sets thermal functions that protect the motor.
f f f f
L2 Power Loss Ridethru
Selects the power-loss processing method.
f f f f
L3 Stall Prevention
Accel/Decel stall prevention settings and selection
f f f f
L
Protection
L4 Reference Detection
Frequency detection settings and selection
f f f f
L Protection
L5 Fault Restart
Fault restart function settings
f f f f
L6 Torque Detection
Sets overtorque detection functions 1 and 2 (by torque)
f f f f
L7 Torque Limit
L
Four-quadrant individual torque limit settings
× ×
f f
L8 Hardware Protection
Hardware overheating and open-phase protection settings
f f f f
o
Operator
o1 Monitor Select Selects the Operator’s display and setting methods.
f f f f
o Operator
o2 Key Selections Operator’s key function selection and other constants
f f f f
7