YASKAWA CIMR-G5A Series - Page 283

8.2 Programming Mode Constants
8-29
Setting
Value
Page
Control Methods
Function
Setting
Value
Page
Flux
vector
Open
loop
Vector
V/f
w/
PG
V/f
Function
1A
Accel/Decel time 2
f f f f
6-17
1B
Constants write enable (ON: All constants can be written-in. OFF: All constants other than
frequency monitor are write protected.)
f f f f
7-70
1C
Trim control increase (ON: d4-02 frequencies are added to analog frequency references.)
f f f f
7-70
1D
Trim control decrease (ON: d4-02 frequencies are subtracted from analog frequency refer-
ences.)
f f f f
7-70
1E
Analog frequency reference sample/hold
f f f f
7-71
1F
Frequency reference terminal 13/14 selection (ON: selects terminal 14) * Enabled only when
H3-09=1F.
f f f f
6-17
20 to 2F
External fault (Desired settings possible)
Input mode: NO contact/NC contact, Detection mode: Normal/during operation
Stopping method: Deceleration to stop, coast to stop, emergency stop or continue operation.
f f f f
7-71
30
PID control integral reset (ON: Reset) f f f f −
31
PID control integral hold (ON: Hold) f f f f −
60
DC injection braking command (ON: Performs DC injection braking) f f f f 7-74
61
External speed search command 1 (ON: Speed search from maximum output frequency)
f
×
f
×
7-74
62
External speed search command 2 (ON: Speed search from set frequency)
f
×
f
×
7-74
63
Energy-saving command (ON: Energy-saving control set for b8-01, b8-02)
f f
× ×
7-13
64
External speed search command 3
f f f f
−
65
KEB (deceleration at momentary power loss) command (NO contact) f f f f −
66
KEB (deceleration at momentary power loss) command (NO contact) f f f f −
71
Speed/torque control change (ON: Torque control)
× × ×
f 7-74
72
Zero-servo command (ON: Zero-servo)
× × ×
f 7-75
77
Speed control (ASR) proportional gain switch (ON: C5-03)
× × ×
f
7-75
8