ACES SYSTEMS Cobra II - View Tail Rotor Balance; View Tail Rotor Chart

Gen II User Manual
8-23 – Tail Rotor Balance Chapter 8 Revision 3.00, April 2020
8.4.1. – View Tail Rotor Balance
After selecting to review a job, the “View T/R Balance” screen appears showing the run
number, RPM at which the data was acquired, amplitude and clock angle of the vibration,
and suggested, as well as the installed, corrections to the rotor. To view a different run
number, press the [] or [] keys. To view the chart information for the job, press the [F1]
“Chart” key and refer to paragraph 8.4.2.
Pressing the [F3] key “Polar” will present a Polar Chart view of the data collected.
8.4.2. – View Tail Rotor Chart
The “View T/R Chart” screen consists of multiple parts; the first shows the chart name, chart
type, default grams per inch influence, name and adjustment ratio of each blade position