Gen II User Manual
10-18 – Fan/Turbine Balance Chapter 10 Revision 2.10, Apr 2020
10.1.7.2. The “All Planes Use the Same ICF:” field is only available if multiple balance
planes were defined in paragraph 10.1.1.4 or 10.1.1.5 above. Use the [] to
toggle the YES / NO answer field to indicate if all balance planes should use the
same influence coefficient.
10.1.7.3. The “All Sensors Use the Same ICF:” field is only available if multiple sensors
were selected in 10.1.1.10 above. Use the [] to toggle the YES / NO answer
field to indicate if all sensors should use the same influence coefficient.
10.1.7.4. The “All Speeds Use the Same ICF:” field is only available if multiple speeds
were selected in 10.1.1.11 above. Use the [] to toggle the YES / NO answer
field to indicate if all speeds should use the same influence coefficient. If using a
single speed balance or “Sel in Job” was selected in 10.1.1.11 above, this option
will not be presented.
10.1.7.5. Use the [] key to move to the next field. Enter an established or calculated
influence for this setup from the keypad. In the “(Balance weight units)/(Vib
units)” field, enter the units of weight, grams or ounces as designated in the setup,
required to reduce one engineering unit of vibration to the lowest possible level.
In the “Deg” field, enter the phase correction in degrees. If these values are
unknown, “0” (zeros) may entered.
10.1.7.6. If the YES/NO toggle fields in 10.1.7.2 or 10.1.7.3 are set to “No”, you will
repeat these steps for the next screens. When all fields are complete per your
requirements, press [OK] to accept and continue.
10.1.8. – Job Identification Screen
10.1.8.1. The Job Identification screen will be displayed where you may enter the optional
information of Customer, A/C Registration and AC/Total Time. Complete each
field as necessary using the analyzer keypad. If Names or Registrations have
previously been entered in this analyzer, you may optionally press the [F1] “Cust”
or [F2] “A/C Reg” key and select a name from the stored list of names. When all
fields are complete per your requirements, press [OK] to accept and continue.
To Next Page
Loading...
Need help?
General
