ACES SYSTEMS Cobra II User Manual

Gen II User Manual
12-22 – Honeywell Performance Chapter 12 Revision 2.20, 20
12.9 - Monitor N1 DEEC Parameters
The Monitor N1 DEEC Parameters option allows the display of the state and data collected by the
N1 DEEC. This option is generally used as a troubleshooting tool when the scan data is
questionable or not being acquired. No data is recorded while in the “Monitor” mode. The data is
collected by polling each parameter from the N1 DEEC. It may take several seconds to scan through
all of the available N1 DEEC parameters.
12.10 - Monitor N1 DEEC (Fast Scan)
The Monitor N1 DEEC (Fast Scan) option displays a limited set of data from a N1 DEEC. Each
data point is averaged. Pressing [F3] will reset the averages. This option is generally used as a
troubleshooting tool when the scan data is questionable or not being acquired. No data is recorded
while in the “Monitor” mode. The data is collected and updated approximately ten (10) times per
second.

ACES SYSTEMS Cobra II Specifications

General

Brand	ACES SYSTEMS
Model	Cobra II
Category	Measuring Instruments
Language	English