ACES SYSTEMS Cobra II - Balance Plane Information Screen

Gen II User Manual
9-13 – Transient Balance Chapter 9 Revision 2.10, Apr 2020
9.1.5. – Balance Plane Information Screen
9.1.5.1. The “Plane ID:” field displays the identifying number for the first balance plane
information. You will complete one of these information screens for each balance
plane as defined in paragraph 9.1.1.6 or 9.1.1.7 above. If you defined only one
balance plane, you will only complete one Balance Plane Information screen.
9.1.5.2. Use the [] key to move to the “Posn Type:” field. This field will define the
terminology used to refer to the weight locations throughout the balance job. The
choices in this field are <Position>, <Hole> or <Blade>. After you exit this field the
remaining references will change to the selected term. Consequently, the fields
described in these instructions are identified generically as “Position”. Your screen
will display the actual term you selected in this field.