ACES SYSTEMS Cobra II - Transient Balance Setup

Gen II User Manual
9-3 – Transient Balance Chapter 9 Revision 2.10, Apr 2020
“Transient Balance Setup” Screen. If you are starting a new job with no setups previously
defined in the analyzer’s memory, the screen will automatically display the Transient Balance
Setup banner screen shown below. See paragraph 9.1.1 below for step-by-step instructions on
completing the Transient Balance Setup.
9.1.1. – Transient Balance Setup
9.1.1.1. The “Transient Balance Setup” banner screen allows you to define and store a
Transient Balance Setup using both fill-in and selection fields. The fill-in fields have
squared off ends ([ ]). These fields are filled in using inputs from the analyzer keypad