Gen II User Manual
22-15 – Analyzer Management Chapter 22 Revision 2.10, Apr 2020
Charge (%) – The current battery level in percent. Should match battery level displayed
in the status pane.
Voltage (V) – The current voltage level of the battery.
Current (mA) – The measure of current flow to and from the battery in milliamps. A
positive value is displayed when the battery is being charged. A negative value is
displayed when there is a demand on the battery.
Temperature (C) – The current battery temperature in Celsius.
Technology – The type of battery.
Serial number – The serial number of the battery installed.
Health – Displays the current “Health” condition of the battery. There are five possible
conditions; “Excellent”, “Good”, “Fair”, “Poor”, and “Very Poor”
Charge Cycles – Number of charging cycles the battery has undergone over the life of the
battery.
Current Charge (mAh) – Current milliamp hour charge level of the battery.
Charge Capacity (mAh) – Current available milliamp hour charge capacity of the battery.
Design Capacity (mAh) – Original milliamp hour charge capacity of the battery.
NOTE
We recommend the battery be charged on a regular schedule and that a job not be started with
less than 25% of full charge remaining. See “Chapter 2, Analyzer Description” for instructions on
charging the battery.
22.4. – Analyzer Legal Information
The “Analyzer Legal Information” selection contains the specific license information related to
the hardware and software used in the analyzer itself.
To Next Page
Loading...
Need help?
General
