Gen II User Manual
22-14 – Analyzer Management Chapter 22 Revision 2.10, Apr 2020
The [F2] “Cal Rpt” key will cause the analyzer to create a calibration report based on the
last successful calibration performed on the analyzer. Pressing this key will cause the
analyzer to display the “Creating Report” screen pictured below. When complete, you
will return to the “Analyzer Owner Information” screen. The report will be added to the
“Pending Reports” stored in the analyzer for transfer to the USB memory device.
22.3.4. – Battery Information
The “Battery Information” function allows the user to check the overall condition of the battery
to include charge status (in percent), voltage, current, temperature, health and number of charge
cycles, etc.
The information displayed on the screen is as follows:
To Next Page
Loading...
